Products
FU type chain conveyor

FU type chain conveyor

Belong to: Auxiliary equipment for conveying and lifting

On the basis of introducing the advanced technology of Japanese chain conveyor, combining the advantages of domestic similar products and summarising the problems in practical application, our company has developed a new generation of perfect conveying equipment-FU chain conveyor, which can be used for horizontal or inclined (less than 15°) conveying of bulk materials. It can be used for horizontal or inclined (less than 15°) conveying of bulk materials. It is widely used in building materials, metallurgy, chemical industry, grain processing and other industries due to its advanced principle, reasonable structure, high efficiency and energy saving and many other advantages.

 

1、High conveying capacity, up to 6m³/h-500 m³/h. 
2、Low energy consumption for conveying, with the help of the internal friction of the material for propelling the material forward pulling force, than the screw conveyor to save 40-50% of electricity.
3、Sealed and safe, the fully sealed casing makes the dust very little spillage.
4、Long service life.
5、Flexible process arrangement, can be multi-point in and out of the material.

 

Model Groove 
Width 
(mm)
Optimum conveying capacity(m³/h) Ideal number of grains  Maximum number of grains (content not exceeding 10%)  Permissible inclination angle  Material humidity 
Chain speed(m/min)
11  13.5  14  17  21  22  27  28 
FU150 150  6-10     10-16   13-20     <4 ≤15° ≤5%
FU200 200  12-18     18-28   25-38     <5 10 
FU270 270  22-33 26-40   33-50   45-68 54-82 86-130 <7 14 
FU350 350      43-64 54-80 66-98     120-180 <9 18 
FU410 410      60-90 73-110 90-135       <11 21 
FU500 500    80-120   105-160 140-200   180-240   <13 25 
FU600 600    120-160   150-220 200-290   240-360   <15 30 

 

When the conveyor is arranged to run at an angle upwards (i.e. with the feed end below and the discharge end above), its capacity will be reduced. In this case, the capacity of the conveyor should be multiplied by the discount factor n according to the following table.

Conveyor Inclination(°) 0-2.5 2.5-5 5-7.5 7.5-10 10-12.5 12.5-15
Discount factorη 0.95  0.9  0.8  0.8  0.7 

 

The driving device of FU type chain conveyor adopts XWD type planetary cycloid reducer. The length L of the conveyor is 0.5 m. The length of the standard middle section of FU150, 200 and 270 conveyors is 2 m; the length of the non-standard middle section is 1.5 m and 1 m. The length of the standard middle section of FU350 conveyors is 3 m; the length of the non-standard middle section is 2.5 m, 2 m and 1.5 m. The process arrangement can choose several standard middle sections and several non-standard middle sections to form the length L. The process arrangement can choose several standard intermediate sections and several non-standard intermediate sections to be combined into the required length L, and choose the standard section combination as far as possible.
There are two kinds of conveyor chains: common type and temperature-resistant type (60℃-110℃). If the material temperature is higher than 110℃, please contact us for special order.